Zitat:
gold maxx power emulator for v3 !!! firstly create a new proggy (copy Hi power prog) name it gold maxx... remove all discrimination so she is effectivly in all metal, switch off threshold, set to tone ID and put tone id in custom mode. set tone id custom mode as follows, -95 to -1 set at low tone such as 160 0 to +45 set to say 183 then finally set +46 to +93 to 195 the +94 & +95 to the lower tone. set filter to 10 khz high recovery to 20, discrim to 80-85 all metal to 65 and sensitivity to a workable level oh and nearly forgot set to 22.5khz single frequency .... VOILA uno gold max power or DEUS as it will still show VDI info etc... The low tone will only sound on iron targets the mid tone will sound on small items such as hammered coins and the high tone will sound out on coppers etc (this way you get to hear everything in the ground and can listen for those pops and blips that sometimes hide a good target !!) !!! you may wish to try it in all three frequencies aswell !!!
|
Quelle:
http://www.findmall.com/read.php?66,1138447
Mit diesen Einstellungen kann man sehr schön die Vielseitigkeit des Detektors demonstrieren.
Hier meine deutsche Zusammenfassung:
- Erstelle ein neues Programm mit der Vorlage "HiPower" und benenne es "GoldMaxx"
- Setze alle Leitwerte auf Akzeptieren, damit das Gerät im Allmetallmodus arbeitet
- Threshold (Schwebeton) abschalten
- Tone ID aktivieren und folgende Ton/Leitwertkombinationen einpflegen:
Leitwerte-95 bis -1 einen niedrigen Ton wie z.B. 160
Leitwerte 0 bis +45 auf Ton 183
Leitwerte +46 bis +93 auf Ton 195
Leitwerte +94 bis +95 auf o.g. Ton 160
- 10 Hz Hoch Bodenfilter aktivieren
- Recoveryspeed (Wiederherstellungs Verzögerung) auf 20
- Discrimination (Ausblendung) auf 80-85
- Einzelfrequenzmodus 22,5 kHz